Select function with RESUME press POWER to execute: Let green light blink until printer is done futzing Hold down RESUME and then hold down POWERģ. Remark “After service mode Pls use software for permanent reset”ġ. Choose (SET DESTINATION 1) And it should be reset. Close door, then release power button.Ģ.Open General Tools software and select (USB PORT)ģ. Press and release the RESUME button again, the indicator (L.E.D.) should be greenĤ. Press and release the RESUME button again, the indicator (L.E.D.) should be green. Press and release the RESUME button, the indicator (L.E.D.) should be orange.ĥ. The indicator (L.E.D.) should be green.Ĥ. Press and hold the POWER button, turn on the printer.ģ. Waste Ink Counter Reset Manual for Service modeġ. Press the POWER button again to restart the printer. (More selections beyond this point – However it is best leave them unaltered – You have been warned!) After selecting the desired mode (eg 4), press the POWER button to “set” the change, and return to the top of the function selection menu. Service/Factory test printout, including ink sensor check.ĥ. The lamp will alternate (change) color with each key press.ġ. (4) Press the RESUME button 4 times, this will select the clear waste ink counter function.

If the above was properly performed the printer will enter the “Service Mode”.

The printer’s carriage will “reset” or move momentarily.

Note: you are still holding the POWER button). (3) Release the RESUME button, Next press and release the RESUME button two(2) more times in succession. (2) Press and hold the RESUME button, then press and hold the POWER button. Ħ: Press and HOLD RESUME/RESET for two seconds or more and release it.ħ: Press and HOLD RESUME/RESET for two seconds or more and release it. 3: Close Front access panel, Hold down the RESUME/RESET button and plug in the AC power cordĤ: Release RESUME/RESET after plugging in the AC Power cord.ĥ: Press the RESUME/RESET once within 5 seconds and release the RESUME/RESET.

Reset canon ip3000